MAC262 – ACFT Limits and Speeds Practice Test

These questions are part of the practice quiz. Start practicing

• Fuel types (divert) include Jet A1 (AVTUR), F34, F35, F44 (AVCAT). Which fuels are allowed for divert?
• What is density altitude and why does it matter for performance?
• What is the prop de-ice current draw range in amps?
• What is Vlo and what does it control?
• Under these limits, when is rudder boost required?
• From Basic Weight to MTOW, how much additional weight is allowed to reach MTOW?
• How does weight influence Vref and Vapp?
• Differentiate IAS, CAS, and TAS with respect to aircraft performance.
• What is the maximum compartment weight?
• What is Vs1g used for in gust-load certification calculations?
• Which speed is marked as Vno, the maximum structural cruising speed, and which arc does it bound?
• What is the operation ceiling?
• What happens if you do not comply with manufacturer-specified speeds?
• How does weight affect stall speed?
• Why is it essential to study aircraft limits and speeds for MAC262?
• How do Vref and Vapp change with weight at landing?
• What is the glide speed?
• Which speed value appears most frequently in the placard values?
• What is Vapp and how is it chosen relative to Vref?
• No Yaw Damper Ceiling is at which flight level?
• In a twin-engine aircraft, how does engine-out performance influence V2?
• What is the amount in each auxiliary fuel tank?
• In icing conditions, which speeds are most critical for safe operation?
• Which statement about flaps during icing is true?
• What is the stall speed with Flaps LAND (DOWN)/Idle (Vs0)?
• What is the minimum icing flight speed?
• In flap-down configuration, what is the minimum load factor?
• What is the Best Angle Single Engine (Vxse) speed?
• Which speed is the maximum speed for gear extension and retraction?
• Which value corresponds to Flap - Landing (Vfe)?
• What is the Manoeuvre (Va) speed?
• Wing inspection lights serviceable status corresponds to which icing scenario?
• Which speed value is used for both Manoeuvre (Va) and Gear Extension (Vlo)?
• What is the Yellow arc and what caution does it represent?
• What is the minimum reverse pitch value?
• The Maximum Cabin Differential Pressure is measured in which unit?
• If the maximum crosswind is 30 knots dry and 20 knots wet, what is the maximum crosswind allowed on a wet runway?
• What is the correct sequence of a landing gear cycle?
• How many cycles are used before the extended off period in the starter limits?
• What is the Best Rate (Vy) speed?
• Which unit is used for the pneumatic pressure specification?
• How does altitude affect the Mmo limit and airspeed control?
• What is the relationship between stall speed and redline (Vne) in normal operations?
• What is turbulence penetration speed and when should you use it?
• To determine if you are operating within the normal operating range, your speed should lie between which two speeds?
• How does Vno differ from Vne?
• What is the maximum Mach number?
• What is V2 and why is it critical after an engine failure?
• The aircraft length is provided as which of the following?
• Landing length (divert) is specified as which distance?
• Which statement correctly identifies Mmo and its application at high altitude?
• What is VMCA with Flaps UP?
• Fuel crossfeed is allowed in which engine configuration?
• Why is it essential to follow manufacturer-specified speeds?
• What is the effect of a 1-g gust on stall margins?
• Operational Temperature Max is defined by two altitude categories. Which pairing is correct?
• Tail height provided is 4.36m. Choose the correct option.
• What is the purpose of color-coding speed ranges on the airspeed indicator?
• Which two weight limits are equal in this configuration?
• In flap-up configuration, what is the maximum positive load factor?
• What is the starter limits cycling pattern?
• The lowest stall speed occurs with which configuration?
• Which value from the following represents Vy (Best Rate) speed?
• What is the gyro suction range for operation below 15,000 feet?
• What is the pneumatic pressure range in PSI?
• Which factors are used to convert Indicated Airspeed (IAS) to True Airspeed (TAS) for performance planning?
• What is the amount in each main fuel tank?
• Vapp is chosen near which reference speed?
• What is stall speed (Vs) and what does it depend on?
• Which statement best describes the purpose of color-coded speed limits in flight operations?
• A landing gear cycle is defined as which sequence?
• How do flaps affect stall, approach, and landing speeds?
• What is the Basic Weight?
• What is the Best Angle (Vx) speed?
• What does the Green arc on the airspeed indicator represent?
• Take-off length for normal operations is what distance?
• What is the total usable fuel?
• Which statement correctly describes the green arc on an airspeed indicator?
• Define Vref and its role in the approach phase.
• What is VMCA with Flaps APP?
• What is the gyro suction range for operation above 15,000 feet?
• What is the maximum fuel imbalance allowed?
• What is the maximum Vmo at sea level?
• In twin-engine performance planning, what is Vmc used to assess?
• The gyro suction range changes at what altitude threshold?
• Vmca stands for and what does it indicate?
• What does Mmo stand for and when does it become the controlling limit?
• Which statement best describes CAS and TAS?
• For operation temperature max above 25000 ft, what ISA deviation applies?
• Which option correctly defines VR in the takeoff sequence?
• What does Vne stand for and indicate?
• What is the purpose of speed planning in performance charts?
• How do you ensure correct liftoff performance with takeoff speeds and limits?
• Which statement about density altitude is correct?
• For a cracked window screen (inner or outer pane but not both), which operating condition is specified?
• What is speed margin?
• What is the maximum RPM for 7 minutes?
• What is the Turb Penetration (Vb) speed?
• What is Vfe and what limitation does it impose?
• In flap-down configuration, what is the maximum positive load factor?
• What is Vle and what does it govern?
• Aircraft Length is listed as which value?
• Why is maintaining V1 and VR important in takeoff?
• Bleed Air Maintain Press - Low: N1 greater than what percent?
• The aircraft length is accurate as 14.2m, 46'8''. Which statement is true?
• What is the maximum zero fuel weight?
• Which weight limit is greater, MTOW or Max Ramp Weight?
• Cat C Limits Initial Approach value is:
• Aircraft Tail Height is specified as which value?
• Engine anti-ice (takeoff) status is OFF under which condition?
• What is the Emergency Descent speed?
• What is Vapp and how is it used on final approach?
• What is the LG Extension (Vlo) speed?
• During takeoff, which speeds are used to assess rotation and engine-out performance?
• What is the White arc and what configurations does it cover?
• Which value is shared by Vyse and Vxse?
• What is gust factor and which speed is used to limit gust-induced loads?
• Vapp is chosen to maintain stabilized approach with margins relative to Vref. Which statement is true?
• What is the Intentional One Engine Inop (Vsse) speed?
• What is the maximum RPM for the propeller, and for how long can it be maintained?
• How do weather and density altitude influence approach speeds?
• What is Vref and how is it typically related to stall speed?
• A cracked cabin window under 25 hours of operation requires which condition?
• What is the maximum number of landing gear cycles allowed before a 15-minute break?
• Why are speed limits color-coded as green, white, yellow, and red?
• Cat C Limits Max Missed Approach value is:
• If both main tanks are filled to the listed Each Main Fuel amount, what is the total in the two main tanks?
• Which speed is the stall speed in clean configuration?
• Which speeds increase with heavier landing weight?
• Which value correctly describes the divert landing length?
• Jet A1 is classified as which fuel type?
• In takeoff planning, which speeds define rotation, climb, and engine-out performance?
• What is the requirement for rudder boost under these limits?
• A cracked window screen is permissible under which condition?
• Which speed value is the highest among the listed performance speeds?
• Vs1g is best described as which speed for gust-load certification calculations?
• Which speed is the maximum operating indicated airspeed at low altitude?
• What is the RPM used for Takeoff and Missed Approach?
• What N1 percentage indicates the normal bleed air limit?
• What does Maximum Imbalance Fuel specify?
• Wing inspection lights serviceable is required during which condition?
• What is the Flap - Land (Vfe) speed?
• PCR (divert) pressure value is which of the following?
• Which VMCA value is higher?
• What is the RPM used for Cruise/Descent (max cruise)?
• What are Vx and Vy and what do they optimize?
• What is the overall purpose of studying limits and speeds in MAC262?
• What is the maintenance interval between engine overhauls?
• How does stall speed Vs change with weight?
• Bleed Air Maintain Pressure - Low is defined as N1 (Gas Generator RPM) greater than what percent?
• Calibrated Airspeed (CAS) accounts for which corrections?
• What is the maximum crosswind limit for dry runway conditions?
• What is the minimum takeoff fuel per main tank?
• What is V1, and what decision does it represent during takeoff?
• What is True Airspeed (TAS)?
• The 150-hour overhaul interval is prohibited if which condition is met?
• Cat C Limits Vat value is:
• Define Vmo and Mmo and explain when each limit applies?
• What is the Flap - Approach (Vfe) speed?
• How does density altitude affect engine output and climb rate?
• A cracked cabin window under 25 hours requires which condition?
• Flaps in icing conditions should not be sustained unless which phase?
• What is the RPM used for Climb?
• The icing additive requirement for fuel temperature applies below which value?
• Which unit is used for the maximum cabin differential pressure?
• Which speed is used to limit gust loads during abrupt maneuvers and turbulence?
• What is the maximum ramp weight?
• What is the wingspan of the aircraft?
• What is the LG Retraction (Vlo) speed?
• What is the stall speed with Flaps UP/Idle (Vs)?
• What is the stall speed with Flaps APP/Idle (Vs1)?
• What is the practice total usable fuel value?
• Cat C Limits Final Approach value is:
• Which Cat C limit uses the value 121 - 140?
• Cat C Limits Max Visual Circling value is:
• For operation temperature max below 25000 ft, what ISA deviation applies?
• What is the maximum takeoff weight (MTOW)?
• What is the Best Rate Single Engine (Vyse) speed?
• Which RPM value is used for Takeoff/Missed Approach, Climb, and Cruise/Descent?
• What is the maximum landing weight?
• How long must a 6th gear cycle be followed by a break?
• What role do performance charts play during takeoff and landing planning?
• If Vs is 52 knots in landing configuration, Vref is approximately which value?
• What is the LG Extended (Vle) speed?
• What is the Vsse value?
• Lighting for divert operations is configured as which type?
• The White arc on the airspeed indicator represents which range?
• Which statement about Vref is true in approach speed planning?
• What voltage is used for battery start?
• Which statement describes how Vmo changes with altitude?
• What is Va and why is it critical for gust loads?
• What is the maximum downwind component?
• How does Mach number interact with the airspeed indicator at high altitudes?
• The Final Approach Cat C limit corresponds to which value?
• What is the significance of a minimum control speed (Vmc) in a twin-engine flight regime?